1. Measure the wall to see how many boards you are going to need.
2. Find and mark all the studs.
3. Mark where you want to cut your boards and use the Miter Saw to cut each board where you marked it.
4. Make sure your boards are staggered the way you want and level. Then nail them into the wall with the Brad Nailer.
5. Repeat these steps (don’t forget to stagger boards as you go).
6. When you reach an outlet use a jigsaw to create the perfect cutout in the board to fit the outlet.
7. When you get to the end of the wall then use leftover boards to create a trim with a table saw to keep give it a nice clean finish.
2. Find and mark all the studs.
3. Mark where you want to cut your boards and use the Miter Saw to cut each board where you marked it.
4. Make sure your boards are staggered the way you want and level. Then nail them into the wall with the Brad Nailer.
5. Repeat these steps (don’t forget to stagger boards as you go).
6. When you reach an outlet use a jigsaw to create the perfect cutout in the board to fit the outlet.
7. When you get to the end of the wall then use leftover boards to create a trim with a table saw to keep give it a nice clean finish.
For additional tips and suggestions; Contact one of our sales representatives today at 972-336-0059! Or visit our website: www.rentalstops.com
PARTY and EVENT selections to choose from Party & Event Rentals in Dallas Fort Worth!
Blog for Rental Stop, Party Rental Store & Equipment Rental Store serving Dallas, Fort Worth, Grand Prairie & Arlington TX 